Robotics Pitstop



Out of stock

SKU: 1293 Categories: ,

The IL420 and IL4208 consists of a GaAs IRLED optically
coupled to a photosensitive non-zero crossing TRIAC
network. The TRIAC consists of two inverse parallel
connected monolithic SCRs. These three semiconductors
are assembled in a six pin dual in-line package.
High input sensitivity is achieved by using an emitter
follower phototransistor and a cascaded SCR predriver
resulting in an LED trigger current of less than 2 mA (DC).
The use of a proprietary dV/dt clam results in a static dV/dt
of greater than 10 kV/μs. This clamp circuit has a MOSFET
that is enhanced when high dV/dt spikes occur between
MT1 and MT2 of the TRIAC. When conducting, the FET
clamps the base of the phototransistors, disabling the first
stage SCR predriver.
The 600 V, 800 V blocking voltage permits control of offline
voltages up to 240 VAC, with a safety factor of more than
two, and is sufficient for as much as 380 VAC.
The IL420, IL4208 isolates low-voltage logic from 120 VAC,
240 VAC, and 380 VAC lines to control resistive, inductive, or
capacitive loads including motors, solenoids, high current
thyristors or TRIAC and relays.

• High input sensitivity IFT = 2 mA
• 600 V, 800 V blocking voltage
• 300 mA on-state current
• High static dV/dt 10 kV/μs
• Very low leakage < 10 μA
• Isolation test voltage 5300 VRMS
• Small 6-pin DIP package
• Material categorization: For definitions of compliance
please see
• Solid state relays
• Industrial controls
• Office equipment
• Consumer appliances


There are no reviews yet.

Be the first to review “IL4208 4208 OPTOISOLATOR 5.3KV TRIAC DIP6 IC 800V”

Your email address will not be published. Required fields are marked *